Wholesale Registration

Supported: Images, PDFs, Word documents (max 10MB)
Selected File:
Size:

How to Measure Axle Length for VW Stub, Micro Stub & Mid-Board Micro Stub Axles

  1. Set your alignment first. Make sure toe-in/toe-out is where you want it before you measure.
  2.  Raise the hub until the axle would sit dead level, at 0° and parallel to the ground.
  3. Take your measurement. Measure from the bottom of the CV cup on the transmission drive flange to the bottom of the CV cup on the stub axle at the brake side (see Fig. A).
  4. Subtract 3/8" to 1/2". The number you’re left with is your total axle length.
  5. Measure both sides. Left and right axles are often different lengths, so don’t assume they match.
  6. Build a mock-up axle. Cut a length of PVC pipe to size. Cut clip grooves into each end: 1/4" from the end for 930 CVs, or 1/2" for 934 CVs. Install your CV joints with the PVC mock-up in place.
  7. Check at full droop. Raise the vehicle until the suspension hangs at full droop (see Fig. B).
  8. Check free play. Move the mock-up axle in and out. You want 3/8" to 1/2" of free play.
  9. Confirm. If you have 3/8" to 1/2" of free play at both ride height (0°) and full droop, your length is correct.

How to Measure Axle Length for Centerboard, Midboard, Outboard

  1. Set your alignment first. Make sure toe-in/toe-out is where you want it before you measure.
  2. Install your CVs. Mount a CV on the transmission flange and one in the floater hub.
  3. Drop to full droop. Raise the vehicle until the suspension hangs at full droop (see Fig. D).
  4. Measure star to star. Measure from the outside edge of the inner CV’s star to the outside edge of the hub CV’s star (see Fig. D).
  5. Add 3/8" to 1/2". At full droop (24°), your clip-to-clip length is 3/8" to 1/2" longer than your star-to-star measurement. Add 3/8" to 1/2" to get your clip-to-clip axle length.
  6. Measure both sides. Left and right axles are often different lengths, so don’t assume they match.
  7. Build a mock-up axle. Cut a length of PVC pipe to size and cut clip grooves 1/2" from each end. Install your CV joints with the PVC mock-up in place.
  8. Check free play. Move the mock-up axle in and out at full droop and with the axle parallel (0°). You want 1/4" to 1/2" of free play (see Fig. C and Fig. D).
  9. Confirm. If you have 1/4" to 1/2" of free play in both positions, your length is correct.